Search

815 results found for "neon"

  1. 285-2424 Emergency Rescue Boats Enclosed Boat Motor - in Sealed Pod W/ Propellor Shaft Sold Out

    $4.00

        Emergency Rescue Boats Enclosed Boat Motor Pod    This enclosed Boat Motor is anchored to the exterior of the Hull through a hole designed for it in the indentations at the rear of the Hull. The Wiring Harness has a plug-in connector for the ESC/Receiver board, no soldering is required, just plug and play. The...

  2. 285-400402 TRAKHAWK Controller Sold Out

    $20.00

    TRAKHAWK- Controller   A 2.4GhZ controller, that pairs with your TRAKHAWK! Your connection will be uninterrupted when playing with other RC toys. 

  3. 285-420016 Front Skid Plate Sold Out

    $5.00

     Front Skid Plate  It is an extension of the Lower Front Chassis and holds the pockets for the Steering Assembly Hinge Pins, it is found just under the Front Bumper. It also holds the pocket for the Lower Suspension Control Arm Hinge Pin, and is a mount for the Front Bumper, and supports the Front...

  4. 285-1101 XXL 2.4 Ghz - Canopy Red Sold Out

    $2.00 $10.00

     

  5. 285-3427 FOCUS - Replacement Li-Po Battery for Controller Sold Out

    $10.00

    This is the replacement 3.7V 450 mAh battery for LiteHawk FOCUS controller. Battery and ChargerTo reduce the overall cost of using your new toy both the Controller and Drone comes with a rechargeable battery and a USB charger. You should expect 5-8 min run time. However you do need to make sure to properly maintain...

  6. 285-426071 RIG - Controller Sold Out

    $25.00

  7. 285-400272 BIG TOM SC - Wheels (2 pcs) Sold Out

    $12.00

      LiteHawk BIG TOM SC Wheel and Track Removal:                                      The Front and the Rear Wheels and Tracks all  remove and replace in the same manner. Remove the screw that secures the wheel or track to the axle on...

  8. 285-1240 SWIFT Propeller (2 pk) Sold Out

    $2.00 $3.00

     For use with 7.4V 400maH Li-Ion powered plane. 108mm x 80mm    LiteHawk SWIFT - Installing Replacement Propeller- Place a flat head screwdriver between the propeller and where the motor shaft enters the motor casing. - Gently pry the damaged propeller off.- Place new propeller on by pushing it straight onto the motor shaft. 

  9. 285-1250 SWIFT Control Horn Set (4 pk) Sold Out

    $2.00 $4.00

     These are enough Control Horns to replace the ones on the Elevator, Rudder, and both Aileron Servo's  LiteHawk SWIFT - Installing Replacement Wing Aileron Control Horns  As shown, locate the slits on the Main Wing ailerons (only one side is shown, but there are two slits - one per aileron). Servo and Pushrods removed for...

  10. 285-420025 Prebuilt Differential Sold Out

    $8.00

    This Differential is all set to be plopped right into your Gear Case ready to go.. Bearings and Drive Cups all ready installed.

  11. 285-2113 CHALLENGER - Rudder Assy Sold Out

    $15.00

     This Rudder Assembly comes ready to install into the support brackets at the rear of the boat.   LiteHawk CHALLENGER - Installing Rudder Assembly & Propeller 1. Remove the nut on the propeller shaft and slide included propeller onto shaft. Reinstall 7mm nut and tighten until it is tight against the propeller, you can see...

  12. 285-1113 XXL 2 AM - Lower CNC Chassis Sold Out

    $1.00 $3.00

     XXL 2 AM - Lower CNC Chassis

  13. 285-428027 C-Chassis - Steering Servo Sold Out

    $8.00

    For LiteHawk CRUSHER MT, SCOUT and NOMAD - The Steering Servo sits in its own little sealed up compartment, safe from dirt and debris, hidden under the front upper cover.  Servo Unit , Servo Horn and Steering Links: With the Front Wheels removed, follow above instructions to remove the Upper and Lower Suspension Arms from the Chassis only, and...

  14. 285-1255 SWIFT Elevator Sold Out

    $2.00 $6.00

      LiteHawk SWIFT - Installing Replacement Tail Elevator Control Horn  - As shown, locate the Slit in the Tail Elevator control surface (Tail is shown removed).   - Push in the Control Horn (285-1250) oriented as shown. - Secure the Control Horn by installing the supplied Locking Clip on the opposite side of the Control Surface...

  15. 285-426072 RIG - Body complete W/Interior, Rally Driver and passenger and a Roll Cage (1piece) Sold Out

    $25.00

    A polycarbonate plastic external shell for the RIG. This Body has a heavier protective plastic, removeable roof, just incase you want to chill at the beach with some open air through the roll cage as you race down the sand. The Roof is a well built piece designed to protect your body shell when attached to...