285-1250 SWIFT Control Horn Set (4 pk)

As shown, locate the slits on the Main Wing ailerons (only one side is shown, but there are two slits - one per aileron). Servo and Pushrods removed for clarity.

- Push in the Control Horns (285-1250) oriented as shown.

- Secure the Control Horns by installing the supplied Locking Clips on the opposite side of the ailerons as shown. You'll hear a slight 'click' as it sets.
*Optionally, lock the clips with a tiny dab of foam-safe CA adhesive or the adhesive of your choice but this will install the Control Horns permanently - you will not be able to remove them without damaging the ailerons.

- Reinstall the Aileron Pushrods as shown. 

- As shown, locate the Slit in the Tail Elevator control surface (Tail is shown removed).

- Push in the Control Horn (285-1250) oriented as shown.

- Secure the Control Horn by installing the supplied Locking Clip on the opposite side of the Control Surface as shown. You'll hear a slight 'click' as it sets. 

*Optionally, lock the clip with a tiny dab of foam-safe CA adhesive or the adhesive of your choice but this will install the Control Horn permanently - you will not be able to remove it without damaging the control surface. 

- Reinstall and set up the Tail Elevator Push rod as shown below (Tail is shown installed). 

- As shown, locate the Slit in the Tail Rudder control surface. 

- Push in the Control Horn (285-1250) oriented as shown.

- Secure the Control Horn by installing the supplied Locking Clip on the opposite side of the Control Surface as shown. You'll hear a slight 'click' as it sets. 

*Optionally, lock the clip with a tiny dab of foam-safe CA adhesive or the adhesive of your choice but this will install the Control Horn permanently - you will not be able to remove it without damaging the control surface. 

- Reinstall and set up the Tail Rudder Pushrod as shown below.