285-1246 SWIFT Pushrods for Elevator /Rudder

- As shown, locate the Slit in the Tail Elevator control surface (Tail is shown removed).

- Push in the Control Horn (285-1250) oriented as shown.

- Secure the Control Horn by installing the supplied Locking Clip on the opposite side of the Control Surface as shown. You'll hear a slight 'click' as it sets. 

*Optionally, lock the clip with a tiny dab of foam-safe CA adhesive or the adhesive of your choice but this will install the Control Horn permanently - you will not be able to remove it without damaging the control surface. 

- Reinstall and set up the Tail Rudder Pushrod as shown below (Tail is shown installed). 

 LiteHawk SWIFT - Installing Replacement Tail Rudder Control Horn 

- As shown, locate the Slit in the Tail Rudder control surface. 

- Push in the Control Horn (285-1250) oriented as shown.

- Secure the Control Horn by installing the supplied Locking Clip on the opposite side of the Control Surface as shown. You'll hear a slight 'click' as it sets. 

*Optionally, lock the clip with a tiny dab of foam-safe CA adhesive or the adhesive of your choice but this will install the Control Horn permanently - you will not be able to remove it without damaging the control surface. 

- Reinstall and set up the Tail Rudder Pushrod as shown below.