• 285-339 XL AUTO Collector's Edition - Complete Heli w/ Battery

  • $40.00

Description

XL AUTO Collector's Edition - Complete Heli w/ Battery: 

This is the complete Heli, with a battery included ( please fully charge before and after using) It does not include the foam foot pads. Try not to lose them. TIP: A small dot of super glue will secure them in place.

 Charging the XL AUTO's Battery.  P.S. The Info Manual is wrong. You can not charge the battery by plugging the charger into the side port on the Heli'. That side port is where you plug the connector from the battery into your heli. To charge, you must plug the connector from the battery into the charger. Tip: Always keep your Heli' turned off, unless you are set to fly. 

                              

 Plug your USB charger into a power source, and the LED light will come on Solid Red.

                              

Now plug your battery connector from the heli', into the USB charger, and the LED light will go out, indicating charging.

                              

A full charge should take about 45 minutes, and the LED light will come back on solid Red, indicating a full charge.

                              

You should expect about 5 to 8 minutes of flight time. Care must be taken with your battery, never let it run right down, it will damage the battery and may not charge. When the heli' starts to slow down, stop, let the battery cool off for 10 minutes then recharge ( recharging a hot battery can cause damage as well.) Tip: If storing, it is safest to store with a fully charged, or at least 65% charged, and left unplugged from the heli'. If storing for more than two months, start maintenance charges to prevent battery deterioration. 

 Synchronize the Controller with the Heli': 

 With the battery plugged into the Heli', and the Heli's start switch turned on, quickly set the Heli' down on a level surface. The Heli's light should be blinking.

        

Now turn on the Controller, and its power light should be blinking with the Heli'.

       

Now move the Left control stick all the way to the top, then move it down to the bottom, and you will hear a beep. The lights on the controller and the heli' will now be solid, and should be bound, and ready to press the Auto take off button, for the rotors to spin.