• 285-1248 SWIFT Servo Set 70 mm Wire

  • $5.00 $15.00

Description

 The SWIFT Servo Set with 70 mm Wire. Are the Servos that you need for the Tail Elevator and Rudder. They come with the Servo Horn and attaching screws.

LiteHawk SWIFT - Installing Replacement Tail Elevator Servo
- Install the Tail Elevator Servo as shown. It's easier if you insert the kinked end of the Pushrod prior to securing the Servo. (For clarity, only the relevant Main Fuselage section is shown. ESC is not shown. Motor is not shown.)

-Tail Elevator Servo is installed into the left Fuselage half.


- We do not use any adhesive to secure the Servo (for ease of replacement) but if you wish apply a tiny dab of foam-safe CA adhesive or the adhesive of your choice.

LiteHawk SWIFT - Installing Replacement Tail Rudder Servo
- Install the Tail Rudder Servo as shown. It's easier if you insert the kinked end of the Pushrod prior to securing the Servo. (For clarity, only the relevant Main Fuselage section is shown. Battery is not shown. Motor is not shown.)

-The Tail Rudder Servo is installed into the Right Fuselage half.


- We do not use any adhesive to secure the Servo (for ease of replacement) but if you wish apply a tiny dab of foam-safe CA adhesive or the adhesive of your choice. 

- If you are only replacing the one Servo.. here are some pictures of where I would carefully cut the Fuselage to remove and replace a defective Servo. Use a very sharp Exacto Knife Hobby Knife or Razor Blade, and remove the whole Servo Cradle section. Replace the Servo and glue the whole section back in place. Hook up the Control wire to the Servo before you glue the Section back in.